Hammertime is reader-supported. We may earn commission from affiliate links.

Applying wallpaper can be a rewarding DIY project. Here’s a step-by-step guide:

1. Prepare the Wall:
– Ensure the wall is clean, smooth, and dry. Repair any imperfections, and if the existing paint or wallpaper is peeling, remove it.

2. Measure and Cut:
– Measure the height of your wall and add a few inches for trimming.
– Cut the wallpaper into strips, aligning the pattern if applicable.

3. Mix Wallpaper Paste (if needed):
– If you’re using traditional wallpaper, follow the manufacturer’s instructions to mix the wallpaper paste. This is a highly rated wallpaper kit from Amazon.

4. Apply Paste or Activate Adhesive:
– For traditional wallpaper, use a brush or roller to apply paste to the back of the paper.
– If using pre-pasted wallpaper, activate the adhesive by dipping the paper in water or spraying it as per the instructions.

5. Book the Wallpaper:
– “Booking” means folding the pasted sides of the wallpaper together, allowing the paste to activate without drying out. Follow the recommended booking time.

6. Hang the Wallpaper:
– Unfold the booked wallpaper and carefully position it on the wall, starting from the top.
– Use a wallpaper smoothing tool or a plastic squeegee to remove air bubbles and ensure smooth adhesion.

7. Trim Excess:
– Use a sharp utility knife or scissors to trim the excess wallpaper at the top and bottom.

8. Repeat the Process:
– Continue hanging strips of wallpaper, aligning patterns as needed.

9. Clean Edges and Corners:
– Wipe away excess paste with a damp sponge and use a wallpaper seam roller to press edges and corners for a secure bond.

10. Let It Dry:
– Allow the wallpaper to dry completely before moving furniture back or adding any decor.

Remember to follow the specific instructions provided by the wallpaper manufacturer for the best results.