Hammertime is reader-supported. We may earn commission from affiliate links. Thanks for your support!

Do you want to make an easy DIY wreath? Let me show you how!

-Grab a straw wreath, like this. Any size will do!

-Grab some wide ribbon. You could really use any width, but I’d recommend getting ribbon that is 2″ or 3″ wide.

-Starting with the end of the ribbon, and hold it on the back of the wreath, at any spot. Begin wrapping the ribbon around the straw wreath at a slight diagonal, so that you are moving the ribbon about 2″ over each time.

-Continue until the entire wreath is covered. Cut the end of the ribbon and tuck it into the backside, or glue it down.

-Now… the fun part! You can add accessories onto the wreath and attach them with pins, glue, etc.

-You can create a hook by cutting a small ribbon (1/2″ or so) to a shorter length (about 6-10″, depending on the size of your wreath), loop it around, and glue or pin the ends to the top. This will leave a loop at the top of the wreath so you can hang it..

-Check out some of these ideas!